How To Dismantle 2008 Suburban Rear Door Window Switch

I have removed the interior panel and confirmed that it receives 14v of power when the switch is pressed but it does not engage the motor to press the release.

How to dismantle 2008 suburban rear door window switch.

This was done on 02 06 chevy avalanche but should be about the same for whats listed below but if your rear door on the tahoe or suburban have a light dont f. In the video 1a auto shows how to remove or replace the interior door panel trim on your vehicle. My 2008 suburban will not release the rear window glass by the door switch or remote. Make sure you put this in correctly.

The replacement switch from 1a auto goes right in clicks in place. Lift up on the rear of the switch plate in order to remove the rear switch plate from the door trim panel. The plastic trim tool is the best tool. You have everything you need from the spacious interior to the super towing power.

Make your ride perfect in all ways with a chevrolet suburban 1500 power window switch replacement from autozone. Remove the power window switch from the switch plate by disengaging the side snap walls with a small flat bladed tool. The purpose of the power window switch is to give the driver and passengers the ease of push button window operation. Disconnect the electrical connector.

Pry out one side press with your thumb down and push and release the clamps and it comes out. Feed the harness down in. The fuses under the hood are good.