How To Fix Old Garage Door Spring

Disconnect the spring from the track bracket and the spring pulley and disconnect the safety cable from one end.

How to fix old garage door spring.

Rotate the drum to wind the cable into the winding grooves. Diy garage door repair and save money. If your garage door cable is at an angle or l. The general process is simple and safe.

Adjust the springs on both sides of the door the same way. If it was opening too quickly move it to the next lower hole. Test the spring by lifting the door about 3 feet. Put on eye.

Leave the locking pliers in place and repeat the tightening procedure on the other side. This video is to inform you of a type of spring and bracket that exists on one piece garage doors with a jam pivot style design. Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. If the door remains in place the replacement was a.

Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. If the door was closing too quickly move the spring to the next higher hole on the bracket. This system is unsafe and sh. Open the door to relieve the spring tension and secure it open with c clamps in the tracks.

Step 1 unplug the garage door opener and clamp the door to the track. Install the new spring reinstall the pulley and reconnect the safety cable and you re done. This video will show you how to repair a mis aligned garage door cable. Disconnect the garage door opener so the door remains closed.

Lubricate the spring with garage door lubricant then remove the clamp from the garage door. Pull the cable as tight as possible before tightening the setscrews.