Immediately level and prepare further using a bull float.
How to flatten concrete wall.
Spread a thin coating of mortar to the underside of tiles before setting them in place on the.
Spread the mortar with a notched trowel allowing the notches to lightly scrape the concrete below.
Sand any particularly bad areas of concrete with rough grit sandpaper.
How to smooth a concrete wall finish step 1.
Step 3 mix the plaster mix your plaster according to the manufacturer s instructions preferably in an area away from drying winds and direct sun.
Do not try to make the wall level.
From the front of the house to the doors the floor slopes up around 7cm but is not too uneven across the width so we re going to put down a thick underlay and carpet.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
Trowel a 3 8 inch.
The bull float should have rounded ends not flat or straight ends.
We have an old victorian house with a concrete floor throughout the ground floor.
For a flat finish apply a layer of dash that is almost liquid in consistency.
A hammer drive anchor requires only a small pilot hole.
Apply a coat of the mixture to your concrete wall before plastering it and allow it to dry for a day.
Avoid using a square float as it.
The one shown requires only a 1 4 inch hole.
The ground floor is partitioned in two by a dividing wall and french doors.