How To Free A Jammed Door Lock

Squeeze the bottle gently to release a few puffs of powdered graphite into the lock.

How to free a jammed door lock.

Try not to use an excessive amount graphite is a potent substance so a little bit will go a long way. A credit card between the door and the frame where the latch is located. You can slide the key into the lock lightly so that the lubricant can get inside the lock properly. Key won t turn in lock i couldn t get my mail so i tried something whilst the camera was rolling and it was almost a miracle result.

You should start by spraying the lubricant simply on the door key. A broken key extractor is one of the easiest ways how to fix a door lock that is jammed in this way to open. If you do not have a proper broken key extractor you can use a jigsaw blade or a pair of tweezers. Spray the lock a few times and allow it a few minutes to work its magic.

When you are trying to figure out how to fix a door lock that is jammed it is necessary to stay patient to avoid causing further damage. Spray general use lubricant into the keyhole and insert the barbed. The first thing you can try for opening a jammed latch is to slide a plastic card e g. Use a key extractor available for purchase at websites that sell locksmithing tools to remedy a lock jammed by a broken key.

Start by connecting the red applicator straw over the spray can nozzle. The straw will increase the accuracy of the spray and enable you to get deep inside the lock. Wet lubricant tends to gum up the locks. This will hopefully force back the latch and the door will open.

How to free a stuck lock. The fix in instances with a door latch stuck because it is jammed by rust and other materials it is always best to disassemble the lock and do a bit of cleaning. If the door lock gets jammed first you should use graphite based lubricant rather than using wet lubricant. Slide in the card forcefully and play with it a bit while shaking the door a bit too at the same time.

Letting the components sit fully submerged in a vinegar of about 5 acidity will do the job of separating the gunk from your metal. Inject some powdered graphite into the lock. Use a file to widen the hole on the strike or remove the strike with a screwdriver and reposition it on the jamb.