How To Get A Closet Door Back On Its Hinge

On the latch side a door is cut at a slight bevel to make it easier to close.

How to get a closet door back on its hinge.

Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track. One requires you to loosen a set screw and slide the bracket in or out. Adjust the height of the doors by screwing the bottom pin in to lower them or out to raise them. Hold door hinge against cardboard and use utility knife to cut around hinge.

Unscrew the screws holding the bottom hinge to the door frame using a phillips screwdriver. Open the door to carefully remove it. Reinsert the pin tapping it gently into place from the top with your hammer. Unscrew the top hinge from the frame.

Lay the door on a flat surface and unscrew the hinges from the door. Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go. Make sure that the top roller properly hinges itself onto the top track and the bottom fits into the bottom track. Release the door and let it swing gently back to the vertical position.

Pushing the door upward into the top track gives the door enough space to fit into the bottom track. Spring loaded hinges are always spread out like a butterfly and mounted flat on the outer frame. The style shown in the photo requires you to lift the door and drop the pin into a different notch in the bracket. If one is loose remove two or more screws and try driving in longer screws.

Remember to make sure that the top rollers are directly above the top track s hinge when pulling the door downward. If it is still swinging open on its own repeat this process with the bottom hinge.