This causes the door to bind when moved or fall off the track or may cause the lock to stop working.
How to get a sliding wooden door back on track.
Installed in each pella sliding door is a mechanism that moves the location of the lower track guide.
Turn each screw counterclockwise to raise the wheels and lower the door so that you can lift the door up and out of the track.
If you don t lower the wheels the door will fall out of the frame when you try to open or close it.
The rollers at the top can also wear down lowering the bottom of the door so that it rubs on the track.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
Overtime pella sliding doors fall out of adjustment.
Raise the wheel by turning the adjustment screw counterclockwise.
First locate the adjustment screws along the bottom of the outside face of the door frame shown or on the door s inside edge.
In this video i demonstrated how to make tracks for a sliding wooden door and a technique to modify your saw blade.
Old 1985 house with pocket doors when rollers come out of track you have a job on your hands.
Both types of doors seldom have a bottom track.
These flush bolt floor keepers are typically located on the bottom of the door in the center and prevent them from swinging at 15 to 30 degree angles.
If your closet door has one you need to remove it before you can put your door back on the track.
Making the adjustments correctly will realign the door to reduce these problems.
Give the screw a clockwise turn and test to see whether the door slides easier.
Feel free to ask me any questions and com.
With the door set aside vacuum up any debris and wipe the track clean.
Remove the floor keeper from your sliding door using a screwdriver.
When the back pocket door hanger is off the track it is a bit more of a problem.
You are going to have to remove the pocket door to get the hanger out where you can work on it.
Locating the back pocket door hanger.
A plastic guide attached to the floor typically keeps the door in place.
Bifold doors consist of two pairs of hinged panels that pivot on a pair of pins.
Sliding bypass doors hang from rollers that glide on a track hidden inside the top jamb of the door frame.
After you lower the door lower the wheels by turning each screw clockwise to secure the door in the frame.
Moving the door when the back side is sliding on the ground is a little difficult.