How To Get Your Garage Door Sensors Aligned

Sometimes the sensor may be beyond repair due to wear and tear and in such a case your best bet is to replace the garage door sensor with a new one.

How to get your garage door sensors aligned.

Proper height for a garage door sensor is 4 to 6 inches 10 2 to 15 2 cm. Slowly rotate sensor back aligning sensor with sending sensor until it lights up green again. When you have a strong green light put it back into the bracket and put the wing nut back on. If you have a laser level you can use it instead of a string to align your garage door.

So here is the step by step guide on how to fix a garage door sensor. If you are unable to get the door closed and the safety sensors are the issue the garage door can be closed by pressing and holding the push button on the wall until down travel is completed. For instance try using the wall switch instead of the remote. An easy way to tell if your garage door sensors are out of alignment is by checking if the exterior led light blinks when you attempt to close the door.

Match like colors to like colors there are usually a black wire and a white wire. If nothing works press and hold the wall switch until the door shuts down. If one of the lights is off they will not allow the door to close. I would suggest that you begin by replacing the sensors.

Connect these wires to the wiring of the new sensors. This explains that the door sensors need to be in perfect alignment in order to work. In this case you will set up the level aligned with one sensor then adjust the opposite sensor until the beam of your laser level is hitting the sensor. Green lights mean the sensors are working while red lights indicate the sensors are not aligned.

Follow these steps carefully and you shouldn t have a problem. Take the string off the mounting brackets and turn the power back on to your garage door. The information provide by aashe is very good. The latest garage door sensors are technologically advanced and even allow you to control the opening and closing through an app on your smartphone.

As you can see adjusting the alignment is actually a lot simpler than you d think. Attach the wires of the new sensors to your garage door system now that you have your hanging wires use your pliers to strip some of the casing back and expose the wires. The sensors are now aligned properly. Join us as we show the step by step process on aligning your safety reverse sensors.