How To Hang Wallpaper On A Angled Wall

Remove all picture hanging nails or screws and switch and outlet plates from the walls.

How to hang wallpaper on a angled wall.

Before hanging anything you ll want to clean and sand the walls and if necessary prep them with a primer. The wallpaper should extend completely into the corner and onto the next wall. Attach 1 keyhole fastener to each corner of the picture with the provided screws. Once you ve picked the art and photos you want hanging on the slanted walls of your attic or a frame home lay those suckers upside down on a surface that won t damage frames of course.

Next you ll roll on the paste gently don t just dump a bunch on starting in a corner. Trim the excess wallpaper on the next wall to inch 6 mm using a sharp knife or razor and a straight edge. Match the pattern of the wallpaper before cutting the next piece. Mark the fasteners on.

When you buy the fastener it. Lay the frame face down then place a carpenter s level flush against the top. Apply paste to the plate then lay it face down on the paper. Paint new walls.

Cut a piece of wallpaper larger than the plate. A carpenter s level has a bubble that. Align the paper so that the pattern matches exactly and so the seam is tight. Some home improvement shops sell hangers specially designed to hang pictures on angled walls but you can pick up regular l brackets and screws that will do the job just as well.

Check the wallpaper label for priming recommendations. Attach the tracing paper to the sloped wall with sticky tape. How to wallpaper angled walls 1. Applying the four keyholes leveling with youlevel and making perfect marks with youhangit.

Cut from the part of the pattern that matches the paper on the wall around the switch. Stand back from the wall and check that your pictures will be in the right place. Hold them both on the wall and adjust the paper to match the pattern on the wall. Keep hanging the wallpaper border until you reach the end of the wall and your piece of wallpaper.