To install the doors install the track on the top of the door s frame.
How to install a sliding closet door pull.
Mark the location for the door pull.
Carefully use a small standard screwdriver to go around and slowly pry the pull off.
Hold the door so the top is tilted backward.
Step 1 position the pull.
Use a small standard screwdriver and finish hammer to remove the small nails.
This assumes you have a solid core pocket door.
The runner is what the wheels roll along so the door can slide back and forth.
Mark the measurement with the edge of another piece of masking tape so that.
Either way let us know how it s going.
Use a razor blade to cut any paint finish between door and pull.
The task is easier if you predrill the holes and use a drill bit on the drill to secure the screws.
Drill a shallow hole in the center drive a screw into the hole far enough to get a grip on the pull two complete turns at least grab the screw with a pair of pliers and pull it out.
Then latch the wheels on top of the door onto the back runner of the top track.
Measure in 1 1 2 inches along the bottom of the tape from the edge of the door that you intend to install the pull at.
The normal height for hardware on an 8 foot door is 36 inches from the bottom side up.
If that doesn t work at least now you may have enough to grab with the pliers without the screw.