How To Install Garage Door Opener Track

Overhead acting garage door track options are best described by the size or radius of the curved track component or by the amount of low headroom the door must fit in.

How to install garage door opener track.

Most common garage door track options. Most units hang from angle irons and metal straps that have holes drilled in them at regular intervals. Insert the hinge and roller into the track and attach to the second door panel. The stripping is shaped like.

The panels will be about 1 4 in 6 4 mm smaller than the opening step 2 lay weather stripping over the bottom door panel. Use a tape measure to carefully record the length and width of the opening. Install the third door panel in a similar manner. Tie the extension spring to the roller track then detach the cable from the bottom bracket with a pair of pliers.

Place the opener on a ladder and use scrap lumber to get it at the height you need. Attach the straps to the power unit with the hardware provided. At a home improvement store purchase some rubber weather stripping. Check to ensure track is parallel to the door then screw the track to the wall framing.

Align the opener s rail with the center of the garage door. Drive in hinge screws to join the first bottom door panel to the second panel. There are five basic garage door track options although the first two are by far the most common ones used in residential installations. Torsion see above which mounts on the header above the door and extension photo 1 which floats above the upper roller track.

Order this size so the panels will be made slightly smaller fitting perfectly in the doorway. Attach the two panels together by screwing the hinges on the top edge of the. Lay the panel flat on a workbench. Bolt the angle irons to a rafter or rafters with lag screws.

Step 1 measure the garage door opening before purchasing panels. Place the second door panel on top of the bottom panel sliding the wheels into the track as you position the door.