How To Install House Door Handle

6 install the interior.

How to install house door handle.

Remove the screws from the face plate behind the handle on the exterior side of the door using a screwdriver or drill driver. How to install a door lock door knob deadbolt. To remove the dead bolt and latch bolt unscrew their faceplates located on the door s inner edge. Now secure the latch to the hole by inserting the screws on the screw holes and tightening them.

Remove all screws from the lever or doorknob on the inside. Gatehouse door handle assembly and installation. Start by inserting the new latch into the latch hole. When the latch is in place insert the external door handle into position.

Slide the faceplate over the door handle and snap it into place. Then insert the interior door handle and connect it to the latch. Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening. In this kit the hole for the allen key is at the bottom of the faceplate.

Step by step directions step 1. Step 3 install the exterior handle photo by ryan benyi. Install the inside. How to install a door lock door knob deadbolt.

Begin by removing the screws from the door knob on the interior side of your door. Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate. This allows you to pull the door. Insert the handleset trim into the middle hole on the front of your door.

There may be only one mounting screw at the base of the plate. In some cases door latch plate mortises might need to be cut or enlarged. Slide the adapter plate into the same hole in the rear of the door and screw these units in place. Step 4 install the new handle and latch.

Replace the existing strike and latch plates in the door jamb with the new ones provided with your set. Install the outside handle if your new door handle attaches to the door at a point below the lower borehole. With the new dead bolt and latch bolt in place fit the handle over the door s existing holes. Repeat this process to attach the other faceplate.