How To Install Wall Panels In Basement

Basement wall finishing systems.

How to install wall panels in basement.

The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall. We paid 14 for each 2 x 4 ft 1 in thick panel. After an initial dry stack to determine the layout and cuts ed and dean are ready to adhere the panels to the wall. You need to make the correct markings on the wall panels so that they can be cut properly.

The panels attach to concrete stone or block walls with rigid foam adhesive and can be cut with a utility knife or a circular saw with a masonry blade. That s a full inch thinner than a standard 2x4 wall. Gently remove any crown moulding baseboards and trim you plan on using again. If you re paneling a room that s below ground level like a basement let the panels acclimate for 48 hours.

Clean the basement and remove any furniture or accessories on the wall. Finished basement walls such as those with painted drywall or wallboard do not require much preparation to attach paneling. Use a level to check that the edge is plumb and press against the wall. This will allow it to adjust to the humidity in a room.

A narrow profile maximizes your basement floor area and simplifies installation. For best results set the paneling in the room for a few days before you install it. Basement to beautiful panels are just 2 in. The foam panels are available in 1 1 1 2 and 2 in.

It is important to ensure that the walls are clean and dry before you install the panels. Watch them do it in less than 10 minutes. Pound a panel nail in each corner to hold the paneling in place while the glue dries. Tape a one foot by one foot square of plastic sheeting plastic kitchen wrap will do to the concrete wall in your basement with duct tape and leave it in place for 24 hours.

Then remove the tape. The fancy walls formerly found only in boutique hotels and fancy cocktail lounges are now a wall covering option for your home. Do it right the first time with basement to beautiful wall. Any do it yourselfer with basic tools and carpentry skill can panel an entire wall alone.

Next comes the process of starting to install the panels. Let the panels sit in the room for 24 hours. Use a rubber mallet to tap the paneling in place. This will prevent them from warping once they re up on the walls.

Spray foam adhesive and special plastic fasteners are used to secure the panels to basement walls. Installing paneling also avoids the mess and expense of installing finishing and painting drywall.