Install Gutter Apron Over Drip Edge

Used to direct water into the.

Install gutter apron over drip edge.

If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter. Home centers sell rolls of 6 in. A gutter apron also known as l metal is installed above your roof decking and sits over the edge of your gutter. In fact a drip edge is necessary to have for every roof and to protect your attic.

Gutter aprons take on an additional role by hanging down an inch or so into the back of the gutter to prevent water from dripping or splashing behind the gutter. While a drip edge is about 2 1 2. The gutter lip and the apron lip go together so essentially you are extending the back of the gutter by 1 11 4 high. It is put under the shingles of an attic to flow water directly into the gutter.

The design of your attic though can affect the installation process. Installing a drip edge or a gutter apron is not as difficult as one would expect. A gutter apron is a long piece of metal fold that starts under the first course of shingles and hangs over the sheathing of the roof. A gutter apron is perfect for directing water into your gutters.

If your attic design has a lot of curvy edges and sides installing a gutter apron would be a preferred option. It installs on the roof edge at the eaves and hangs into the gutter. Gutter aprons take on an additional role by hanging down an inch or so into the back of the gutter to prevent water from dripping or splashing behind the gutter. Both of these materials have identical functions.

This directs water straight into the gutter system and also protects your roof line from excess moisture. A gutter apron is installed on the corners above roof decking. Then it is slipped under normal drip edge. A gutter apron is used where shingles are not far enough from the edge of the gutter.

Gutter aprons are installed right under your shingles as well. The hangers have a slight angle to them and actually you screw through the apron portion right into the fascia just works out that way because of the angle of the hanger.