Install Recessed Lighting In Existing Ceiling No Attic Access

The housings and trim themselves aren t that expensive i picked up some 4 halo retrofit can lights for about 17 each from lowe s and trim for about 20 each at home depot.

Install recessed lighting in existing ceiling no attic access.

Drill a 1 4 inch hole in the ceiling at the center of the proposed opening. Without an attic recessed lights must be installed from below the ceiling instead of the top. When the can is installed into the ceiling clamps on the side expand securing the fixture. Unfortunately though a retrofit installation for those of us without attic access can also get pretty expensive if you hire someone to do the work for you.

Run electrical cable through the ceiling from the recessed light hole over to the light switch hole. If necessary go into the attic and make sure there are no wires pipes or ductwork behind the proposed opening. Mark the spot on the ceiling where the recessed lighting fixture is to be installed. Use an electronic stud finder to locate two adjacent rafters and mark a spot half way between them as the.

If the area above the ceiling is a finished space you can insert a coat hanger or fish tape through hole to check for any obstructions. Remodeling recessed light housing is the required model for the project. How to install recessed lighting even without attic access materials needed. Cut the cable with wire.

Insert the electrical cable into the cable clamp on the remodelling recessed light housing. Recessed lights commonly called can lights offer a pleasing finish to virtually any room and make for a reliable source of inconspicuous lighting. Pull the end of the cable out of the wall by 6 inches with fish tape. But some homeowners may be reluctant to install them if they don t have access to attic space above the room where they would like to have the can lights installed.

Recessed can lights are flush mounted with the ceiling. With a utility knife cut off 3 inches from the outer insulation jacket of each end of the electrical cable to expose the internal insulated wires and bare copper grounding wire.