Installing Led Awning Lights

As extra precaution you could put painters tape over drill location before drilling.

Installing led awning lights.

Strips of led lights white and color changing awning lights. September 4 2015 i recently decided to add a set of led strip lights to our trailer. Under rv led pod light kit with 8 bright lights. Next we re going to mount the second led light bar to the first.

Just measure your awning cut and mount your lights wire them in and you can start enjoying your newly lit outdoor living space. I was able to do this without any drilling into the tailer by utilizing th. This strip can be mounted in many places however the best site for mounting the led awning light is just under the awning extrusion that is fastened to the sidewall of your unit please see pictures. Remove the cover to the two sided tape and center the led on the awning arm.

Route the cord to your interior 12v source and plug it in. Do not use strip lights under a vehicle this is the correct way to get. The best way to fit the led strip light onto the av awning is to use either super glue double sided tape or if the lights have been purchased with drilling holes drilling these onto the metal in the awning. You can also try running your cords through the hole where the awning wiring comes out.

Adding an led light strip to your rv awning buy how to hardwire awning lights led lights mod rv awning led light installation rv led strip lights rvgeek strip light. A much harder project is shortening your rv awning which is still very doable. Cover the exposed wires at the end of the light strip with shrink wrap. Use new sharp bit and drill with modest pressure.

Everything is now good. A full underlighting kit for your rv or other vehicle. Installing led strip lights under your awning or on your awning roller is a great diy project that s not too hard with the right tools. Fitting the led strip light to the av awning.

Installing an rv led strip light. Connect and tighten the connectors over here and as i ve said before the awning arm is already prepped and cleaned to insure proper adhesion. And press again all along. Use a straightened coat hanger to determine where the wiring comes out at in the interior.

These very bright rgb pod lights cabels and control box are fully weatherproof.