Installing Tar Paper Under Siding

Our new build house has been standing without siding for two years.

Installing tar paper under siding.

Use tyvek over building felt under siding. Install all subsequent courses with the same overlap until the top edge of the paper is within 6 inches of the roof s peak. Working with a helper unroll the paper so it is about 2 inches below the sill plate and pull it taut. The house will have a rain screen gap made of strips of pt plywood.

Some roofers prefer to attach felt underlayment with 1 inch roofing nails or special nails with plastic washers but most codes allow staples which are easier to drive. I am about to replace the weathered tar paper with two new layers of 15 felt before siding the house with cedar clapboards. Position the next course of tar paper farther up the roof so that its lower edge overlaps the upper edge of the paper in the first course by 1 foot. Check that it is level and aligned and drive staples or cap nails.

If you will be attaching the building paper with cap nails use a chalkline to mark the sheathing with the locations of studs. Tack the end of the paper to the wall using a construction stapler. I saw a new house with felt paper under the siding rather than tyvek. Before applying roofing you ll need to cover the sheathing with roofing felt also often called tar paper most local codes call for using 30 pound felt.

Another great installation tip is to make sure the first strip of tar paper is installed so it overlaps the top of the foundation at least an inch. Faq s acronym s terminology to tyvek or not to tyvek that is the question. We re in the coastal rainforest of southeast alaska very wet. I want to replace the tar paper but i can t find it at homedepot or lowes.

The walls are intended to dry to the outside. Hold a roll of felt paper against the left edge of the wall with the top end of the roll aligned with the chalk line.